No. 84 Weep-Thru Mortar Deflector:

The Weep-Thru Mortar Deflector is designed to catch mortar droppings and allow masonry cavity drainage through the weep holes. It has a three dimensional geometric patterned core and is designed to be 10 inches (25.4 cm) high in the cavity wall.

Features:

-Allows cavity drainage and protects flashing.
-When properly installed, will prevent clogging of  weepholes.
-Will not grow mold.
-Polymer core is resistant to most known corrosive chemicals, including solvents.
-10 inch width suspends mortar droppings above the weep holes, but below the flashing connection to the interior wall.
-Easy installation. No mechanical fasteners required.

No. 365 Trash Mortar Diverter™:

The trash mortar diverter creates a trash mortar collector and acts as a moisture and air flow control system. It stops and collects trash mortar and holds it away from the face brick and the back-up walls. The V-Shape funnels moisture toward the center of the cavity, away from the back side of the face brick and the face of the back-up wall, then downward through three rows of holes to a weep system.

Product Submittal sheet html
Product Submittal Sheet PDF

Click HERE for
Test Report on 365 Trash Mortar Diverter™ and Cavity Vent™ Weep System

No. 366 Cavity Vent™ Weep System:

For Brick Veneers. The Cavity Vent™ Weep System creates many openings at the lowest point of the cavity or core of the wall, continuously along the wall.

Product Submittal Sheet html
Product Submittal Sheet PDF

Click HERE for
Test Report on 366 Cavity Vent™ Weep System and Trash Mortar Diverter™.

No. 367 Core/Cavity Vent™ Weep System:

For CMU. The Core/Cavity Vent™ Weep System creates many openings at the lowest point of the core and cavity of the wall, continuously along the wall.

Product Submittal Sheet html
Product Submittal Sheet PDF

No. 85 Cell Vent:

Install in the bottom vertical mortar joint of a brick wall. Cell Vents consist of many small adjacent passageways. The cellular composition provides easy drainage for moisture along the full height of the head joint.

Reguar:3/8” wide x 2-1/2” high x 3-3/8” long
 (9.5 mm x 63.5 mm x 85.7 mm)
Jumbo:3/8” wide x 3-3/8” high x 4” long
(9.5 mm x 85.7 mm x 101.6 mm)
Colors: Clear, Gray, and Brown

Product Submittal Sheet PDF

No. 330 Plastic Weephole:

3/8" dia. (9.5 mm) clear plastic tube [1/4" (6.3 mm) i.d.] clear plastic tube, 4" (102 mm) long or cut to length specified.

Download 3-D Cad File