|
Pos-I-Tie® Brick Veneer Anchoring Systems Your
BEST solution for
attaching masonry veneers
to
backup walls!
This brick veneer system drills
through insulation and makes contact with the
stud. This allows all compression and tension
forces to interact with the stud and not the
insulation/board. The actual hole is then sealed
with a neoprene washer.
There
are now three
variations of the Pos-I-Tie®
brick veneer anchoring system
to suit your project needs.
For more information on the Pos-I-Tie® Brick Veneer System, click on one of the logos below. |
| |
|
|
The #1 most specified brick veneer anchor. Featured in masonry construction projects for over 20 years! |
|
The new and improved version of the Original Pos-I-Tie®, featuring an adjustable wing nut and easier installation! |
|
Same features as the Wing Nut Pos-I-Tie® but also featuring a special plastic wing nut which reduces thermal conductivity! |
|
| |
|
|
|
| |
|
|
|
|
| |
|
|
|
| |
|
|
|
|
| |
|
|
|
| |
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
#312: L-Type Veneer Anchor
Available
in 3/4" (19 mm), 1-3/4" (44 mm), and
2-3/4" (70 mm) lengths x 1-1/4" (32
mm) wide x 16 gage with 7/32" (5.55 mm)
dia. holes centered in bend and 3/8" (9.52
mm) from end of projection leg. Use 1-3/4"
(44 mm) projection with 1" (25.4 mm) thick
insulation and 2-3/4" (70 mm) projection
with 2" (51 mm) insulation.
#258: Single Pintle Tie 3"
(76 mm) and 5" (127 mm) long with 2"
(51 mm) bends of adjustment and anchoring. 3/16"
(4.76 mm) dia. wire. NOTE: Check local codes
for acceptance of #312 and #258 system! |
|
|
| |
|
|
| |
|
|
|
|
|
|
| Back
To Top |
|
