Moisture Control & Weep Systems
 
Heckmann Building Products, Inc. ~ Proudly Celebrating Our 91stYear in Business!  
 
Home / Products / Moisture Control & Weep Systems    
Moisture Control & Weep Systems
 
#84: Weep-Thru Mortar Deflector

The Weep-Thru Mortar Deflector is designed to catch mortar droppings and allow masonry cavity drainage through the weep holes. It has a three dimensional geometric patterned core and is designed to be 10 inches (25.4 cm) high in the cavity wall.

Features:
    #84
Submittal Sheet
 
  • Allows cavity drainage and protects flashing.
  • When properly installed, will prevent clogging of weepholes.
  • Will not grow mold.
  • Polymer core is resistant to most known corrosive chemicals, including solvents.
  • 10 inch width suspends mortar droppings above the weep holes, but below the flashing connection to the interior wall.
  • Easy installation. No mechanical fasteners required.
 
#85: Cell Vent

Install in the bottom vertical mortar joint of a brick wall. Cell Vents consist of many small adjacent passageways. The cellular composition provides easy drainage for moisture along the full height of the head joint.

Reguar:
3/8” wide x 2-1/2” high x 3-3/8” long
 (9.5 mm x 63.5 mm x 85.7 mm)

Jumbo:
3/8” wide x 3-3/8” high x 4” long
(9.5 mm x 85.7 mm x 101.6 mm)

Colors:
Clear, Gray, and Brown
    #85
Submittal Sheet
 
 

   With Brass Screen & Wick


            With Wick

#330: Plastic Weephole

3/8" dia. (9.5 mm) clear plastic tube [1/4" (6.3 mm) i.d.] clear plastic tube, 4" (102 mm) long or cut to length specified.


Weep Vent Options:

- With Brass Screen
- With Brass Screen & Wick
- With Stainless Screen
- With Stainless Screen & Wick
- With Wick

- Plastic Tube only
    #330
Submittal Sheet
3D C.A.D. Details
 
With Brass Screen Plastic Tube          
 
#365: Trash Mortar Diverter™

The trash mortar diverter creates a trash mortar collector and acts as a moisture and air flow control system. It stops and collects trash mortar and holds it away from the face brick and the back-up walls. The V-Shape funnels moisture toward the center of the cavity, away from the back side of the face brick and the face of the back-up wall, then downward through three rows of holes to a weep system.



#366: Cavity Vent™ Weep System

For Brick Veneers. The Cavity Vent™ Weep System creates many openings at the lowest point of the cavity or core of the wall, continuously along the wall.



#367: Core/Cavity Vent™ Weep System

For CMU. The Core/Cavity Vent™ Weep System creates many openings at the lowest point of the core and cavity of the wall, continuously along the wall.
    #365
Submittal Sheet
 
  #366
Submittal Sheet
 
  #367
Submittal Sheet
 

HomeProductsSpecificationsSubmittalsTest DataC.A.D. L.E.E.D.Quotation RequestsAbout UsContact
Materials/ FinishesM.S.D.S.Credit ApplicationTerms of Service

 
Copyright © 2014 Heckmann Building Products, Inc. - All Rights Reserved