HECKMANN BUILDING PRODUCTS INC.
1501 N. 31st Avenue
Melrose Park, IL 60160-2911
800-621-4140 and 708-865-2403
FAX: 708-865-2640

SUBMITTAL SHEET: #1052 ANGLED FLASHING

Made To Order

Maximum Length of piece is 10 feet. Usually made of 26 gage Type 304 Stainless Steel. Mill Galvanized Steel is also available. Specify size of the two angle dimensions and the degree of angle. The small lip at the bottom is usually 45 degrees and 1/2" long.

Steel sheets used to fabricate this angle are usually 10 feet long x 36 inches wide or 48 inches wide. If possible, plan your flashing measurements to be evenly divisible by 36 or 48 inches to avoid costly scrap charges.

Heckmann Building Products Materials and Finishes: Stainless Steel: Sheet Metal Anchors and Ties: ASTM A 167 AISI Type 304. Plate and Bent Bar Anchors: ASTM A 666 AISI Type 304. Wire Ties and Anchors: ASTM A 580 AISI Type 304. Mill Galvanized: Sheet Metal Anchors and Ties: ASTM A 653 G60 Wire: ASTM A 641 (0.1 oz/ft2)

Specification MSWord

Specification PDF

Heckmann Home Page

© Copyright 1999 Heckmann Building Products Inc.